Filtration; Replacing The Air Filter - Christie J Series Service Manual

2.0, 2.4, and 3.0 kw

Hide thumbs Also See for J Series:

Table of Contents

Filtration

Filters help to reduce the effects created by dust, smoke, fog, and other foreign materials from

entering the projector.

Notice. If not avoided, the following could result in property damage.

•

Do not operate the product without the filter installed.

•

Use only high efficiency Christie approved filters.

•

Do not reuse an old air filter.

The is filter located at the front of the projector.

Replace the filter every 1000 hours. If you are working in an extremely dusty environment, replace

the filter sooner. If this filter is not replaced, airflow can become restricted and cause the projector to

overheat. Use the filter provided in the approved lamp and filter kit for your specific projector model.

1. Loosen the lock screw at the top of the filter door.

2. Lift the door away from the projector.

3. Remove the old filter and insert the new filter with the directional arrows pointing into the

projector.

4. Replace the filter door.

5. Tighten the lock screw.

J Series Service Guide–2.0, 2.4, and 3.0 kW

020-100739-05 Rev. 1 (02-2018)

Table of Contents