Removing The Fold Mirror - Christie J Series Service Manual

9. Push the spacer until it rests against the lens.
10. Carefully insert the 66 mm lens #2 into the optical housing, ensuring the curved face is
inserted first.
11. To finish installing the optical lens doublet, complete steps 4 to 1.

Removing the fold mirror

Complete the following procedure to remove the fold mirror.
Wear nitrile gloves when handling the fold mirror. Hold the mirror only on its edges.
Estimated time to replace: 9 minutes.
1. Remove the lens side cover (on page 38).
2. Disconnect the LiteLOC sensor harness.
3. Remove the two screws securing the LiteLOC sensor.
4. Loosen the bottom LiteLOC sensor screw.
5. Remove the four fold mirror screws.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
75