Temperature Sensors; Obtaining An Error Log; Resolving Problems While Saving An Error Log - Christie J Series Service Manual

Temperature sensors

The following table provides details about the temperature sensors
ID Interface
2 I2C
3 I2C
9 Single Wire
10 Single Wire
13 Single Wire
14 Single Wire
15 Single Wire
16 Single Wire

Obtaining an error log

For the interrogator to successfully retrieve diagnostic files, the projector must remain in its failed
state while the interrogator is operating. Always run the interrogator before power cycling the
projector; otherwise, important diagnostic files become unusable.
1. Open a web browser and type the IP address of the projector into the address bar.
2. Select the appropriate language from the language list, located in the upper left-hand corner of
the WebUI.
3. Sign into the WebUI using the administrator user name and password (case-sensitive).
4. Select the Admin tab.
5. On the right side panel, click Interrogate.
6. Once the download is complete, click Save.
If the file download window does not appear, see Resolving problems while saving an error log
(on page 25) for troubleshooting options.

Resolving problems while saving an error log

If Internet Explorer is set to automatically open or save files without a prompt, or if any popup blocker
has been enabled, the file may not be saved.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Troubleshooting
Location
Projector exhaust temperature
Projector air intake temperature
Located on the main panel driver and
monitors the panel driver board
temperature
Located on the image processor board
Located on slot 1 option card and monitors
option card temperature
Located on slot 2 option card and monitors
option card temperature
Located on slot 3 option card and monitors
option card temperature
Located on slot 4 option card and monitors
option card temperature
25