Lens Mount Components; Removing The Lens Mount Dust Boot; Removing The Ils Lens Mount - Christie J Series Service Manual

Lens mount
components
The lens mount provides a means of securing a projection lens to the projector.

Removing the lens mount dust boot

The rubber lens mount dust boot is located at the front of the projector. This dust boot serves as a
seal between the front skin and the lens mount.
Estimated time to replace: 7 minutes.
1. Remove the top cover (on page 36).
2. Remove the front cover (on page 36).
3. Remove the six screws securing the dust boot to the front skin.
4. Remove the dust boot.
5. To re-install, complete these steps in reverse order.

Removing the ILS lens mount

Complete the following procedure to remove the ILS lens mount.
Estimated time to replace: 11 minutes.
1. Remove the top cover (on page 36).
2. Remove the front cover (on page 36).
3. Disconnect the five lens mount harnesses from the lens mount.
4. Remove the four screws securing the lens mount to the light engine.
5. Remove the lens mount.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
87