9. Remove the three screws securing the panel and then slide the light tube away from the lens.
10. Remove the rear light tube.
11. To re-install, complete these steps in reverse order.
Removing the LiteLOC assembly
Complete the following procedure to remove the LiteLOC assembly.
Estimated time to replace: 4 minutes.
1. Remove the lens side cover (on page 38).
2. Disconnect the LiteLOC harness.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
85