Remove The Liquid Coolant Module From The Projector (Optional); Power Cord And Attachments - Christie J Series User Manual

Section 5: Maintenance

5.4.3 Remove the Liquid Coolant Module from the Projector (Optional)

1. Use a 6 mm hex driver to remove the 2 bolts securing the top frame bracket.
2. Disconnect the electrical connector by depressing the lock tab and pulling.
3. Disconnect the liquid connectors from the liquid coolant module by pushing and turning counterclockwise.
NOTE: The connectors are leak free and will not leak when connecting or disconnecting.
4. Using a 3 mm hex driver, remove the 4 screws securing the liquid coolant module to the projector.
5. Carefully lift the liquid coolant module out of the projector.
6. Check liquid coolant level. See
7. If necessary, refill the liquid coolant. See
8. Replace the liquid coolant module by reversing steps 1-5 above.
5.5

Power Cord and Attachments

• Only use attachments or accessories recommended by Christie, such as the specific power cord supplied. Use
of other attachments or accessories with this projector may result in the risk of fire, shock or personal injury.
• Do not allow anything to rest on the power cord. Locate the projector where persons walking on it or objects
rolling over it cannot abuse the cord.
• Operate the projector at the specific voltage only. Do not overload power outlets and extension cords as this
can result in fire or shock hazards.
• The projector is equipped with a 3-wire plug having a third (grounding) pin. This is a safety feature. If you
are unable to insert the plug into the outlet, contact and electrician to have the outlet replaced. Do not defeat
the safety purpose of the grounding type plug.
• This product can be connected to an IT power distribution system.
5-8
5.4.1 Check Liquid Coolant
Left
High leakage current. Earth connection essential before connecting supply.
Level.
5.4.2 Refilling Liquid Coolant Module.
Right
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)