Remove The Lamp Module; Insert The New Lamp Module; Remove Retaining Bar - Christie Roadster User Manual

Roadster, Matrix WU, Mirage S+/HD/WU User Manual
020-100002-05 Rev. 1 (02-2010)
Figure 4.4. Remove Retaining Bar

5. REMOVE THE LAMP MODULE

Firmly grasp the handle and pull the lamp module straight out of the projector.
See Figure 4.5. Discard the lamp using safe disposal/recycling practices.
Figure 4.5. Remove Lamp Module

6. INSERT THE NEW LAMP MODULE

Align the base plate of the new lamp
module under both side alignment guides
(see right). Slide the module fully into the
projector in the same orientation you
removed the old lamp module. Push with
normal force until the resistance increases,
then firmly push module another ½ inch.
NOTE: The lamp module must make full contact with the lamp connectors.
Increased resistance when sliding the module in indicates initial contact with
these connectors—push firmly at this point.
Maintenance
4-11