Section 4: Parts and Module Replacement
4.9
PCBs and Electronics
4.9.1 Remove the LCD/Keypad Assembly
(10 minutes)
1. Remove the top cover. See
2. Remove (2) black #2 Phillips® screws, which secure the keypad to the
card cage.
3. Remove (1) 3 mm hex screw from the rear of the assembly.
4. Remove (4) #2 Phillips® screws, which secure the backing plate
bracket to the rear of the assembly.
5. Remove the IR sensor harness and the keypad harness to remove the
whole module from the projector.
4.9.2 Remove the LCD Display
(12 minutes)
1. Remove the LCD/Keypad Assembly. See
Assembly.
2. Remove (4) #2 Phillips® screws from the LCD display.
3. Disconnect the LCD flex cable harness. Remove the LCD.
4.9.3 Remove the Built-In Keypad
(12 minutes)
1. Remove the LCD/Keypad Assembly. See
Assembly.
2. Remove (7) #2 Phillips® screws from the keypad assembly.
3. Remove the keypad PCB.
4-24
OBSERVE ALL ELECTROSTATIC PRECAUTIONS! Use a grounded wrist strap
when handling electronic assemblies.
Remove the Top
Cover.
Remove the LCD/Keypad
Remove the LCD/Keypad
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)