Removing And Installing The Lens - Christie DWU8902-GS User Manual

Table of Contents

•

Horizontal image offset: +/-30%

-30%

Removing and installing the lens

When handling the projector after lens installation, make sure the front lens cap is placed on the

lens to protect the lens surface from potential damage. When carrying or moving the projector, do

not handle by the lens. This may damage the lens, the chassis, or other mechanical parts within the

projector.

1. Center the lens. Ensure the lens is at or near its center position. Attempting to remove the lens

with a large offset may cause damage to the lens assembly.

Center the lens while the projector is switched on by pressing the Lens Horizontal or Lens

Vertical button and then pressing Enter.

2. Turn off the projector.

3. Allow the projector to cool down into standby mode before replacing the lens.

4. After the projector has cooled down and prior to replacing the lens, remove the power cord.

5. To remove the lens, press the Lens Release button

lens counterclockwise by a quarter

GS Series DWU8902-GS User Manual

020-001795-01 Rev. 1 (04-2020)

+30%

to release the lock.

by hand or with a tool and rotate the

Installation

Table of Contents

Gs series