Table of Contents
Advertisement
Calibrating the lens motor
Make sure the lens motor is calibrated before using the projector.
If the lens motors are not calibrated properly, implications may include:
•
Incorrect reporting of the lens motor position.
•
Inability to use the full range of the lens motors.
•
Lens motors traveling outside of the pre-defined keep-out area.
•
Damage to the projector.
Calibrate the lens motors when any of the following conditions are met:
•
After a lens change.
•
After the projector is moved and/or jostled.
•
After any manual adjustment is made to the zoom or focus.
To calibrate the lens:
1. Select MENU > Configuration > Lens Settings > Lens Calibration.
2. Select Enter.
Removing the projection lens
Use the correct method of removing the lens.
1. Turn off the lasers.
2. Push in and hold the lens release button.
Christie Griffyn Series Installation and Setup Guide
020-103314-12 Rev. 1 (07-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
35
Advertisement
Table of Contents
