Mini-Sas Cables - Christie CineLife+ CP4415-RGB Service Manual

Mini-SAS cables

The mini-SAS harnesses move data from the card cage to the light engine.
1. Remove the top cover (on page 44).
2. Take note of the routing of the mini-SAS cables.
You must match the routing when you install the new cables.
3. Disconnect the red, green, and blue mini-SAS harnesses from the card cage through the
projector service access door and from the top.
4. Remove the light engine.
5. Disconnect the red, green, and blue mini-SAS harnesses from the light engine.
6. Replace the mini-SAS harnesses.
7. Reconnect the mini-SAS harnesses to the light engine.
Make sure the access and bends are identical to what was installed or the harnesses do not
route properly.
8. Re-install the light engine.
9. Reconnect the mini-SAS harnesses to the card cage.
10. Reconnect the shutter harness.
CineLife+ 4K-RGB Service Guide–CP4415-RGB, CP4420-RGB, CP4425-RGB, CP4435-RGB
020-103257-02 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Harnesses
121