Section 5: Parts and Module Replacement
5.4
Removing Projector Covers
5.4.1 Shroud
Remove the shroud as follows:
1. Using finger pressure, push down on the
locations specified (Red Arrows). See Figure
5-1.
2. Carefully slide the shroud sideways and
forward away from the MLM and lens.
3. Place the shroud covers on a clean service to
prevent scratches.
5.4.2 Front Top Lid
Remove the top lid to gain access to the liquid
cooling system, the IOS for integrator adjustments
and the high security lid.
(Estimated Replacement Time: 2 minutes)
1. Unlock front top lid using the low security key
provided. (Figure 5-2)
2. Lift the lid up and remove.
5-6
Never operate the projector or the fans without all the covers installed.
Figure 5-1 Shroud Removal
Figure 5-2 Front Top Lid
CP4230 Service Manual
020-100622-04 Rev. 1 (05-2016)