Mini-Sas Cables - Christie Cinema 4K-RGB Service Manual

Mini-SAS cables

The mini-SAS harnesses move data from the card cage to the light engine.
1. Remove the top cover (on page 38).
2. Take note of the routing of the mini-SAS cables.
You must match the routing when you install the new cables.
3. Disconnect the red, green, and blue mini-SAS harnesses from the card cage through the
projector service access door and from the top.
4. Remove the light engine (on page 73).
5. Disconnect the red, green, and blue mini-SAS harnesses from the light engine.
6. Replace the mini-SAS harnesses.
7. Reconnect the mini-SAS harnesses to the light engine.
Make sure the access and bends are identical to what was installed or the harnesses do not
route properly.
8. Re-install the light engine.
9. Reconnect the mini-SAS harnesses to the card cage.
10. Reconnect the shutter harness.
Cinema 4K-RGB Service Guide–CP4315-RGB, CP4320-RGB, CP4325-RGB, CP4330-RGB
020-102713-06 Rev. 1 (08-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Electronics
54