See
Replacing the main board and media board
3. Remove fans 4, 5, 6, and 7.
See
Replacing fans 4, 5, 6, and 7
4. Release the two quick-disconnectors of the pump and radiator module.
5. Remove the 11 M3 screws with a Phillips #1 screwdriver.
6. Take out the pump and radiator module.
7. Replace the pump and radiator module.
8. To re-install, follow these steps in reverse order.
Replacing the DC 12V power supply
To remove the DC 12V power supply, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board and main board bottom shielding.
See
Replacing the main board and media board
3. Remove the rear cover.
See
Removing the rear cover
4. Remove the front cover.
See
Removing the front cover
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 99.
on page 72.
on page 64.
on page 99.
on page 64.
on page 65.
Electronics
87