2. Remove the main board and main board bottom shielding.
See
Replacing the main board and media board
3. Remove the eight M3 screws with a Phillips #1 screwdriver.
4. Remove the eight hex screws with a M3 socket driver securing the rear cover module.
5. Remove the rear cover module from projector.
6. Remove the rear IR sensor board.
See
Replacing the rear IR sensor board
7. Remove fans 1, 2, and 3.
See
Replacing fans 1, 2, and 3
8. Transfer the rear IR sensor board and fans 1, 2, and 3 to the new rear cover.
9. If required, replace the rear cover.
10. To re-install, follow these steps in reverse order.
Removing the front cover
The front cover provides access to the lens assembly and front IR sensors.
1. Remove the top cover.
See
Removing the top cover
2. Remove the LED board.
See
Replacing the LED board
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 99.
on page 98.
on page 71.
on page 64.
on page 97.
Projector covers and feet
65