Replacing The Complete Light Engine - Christie HS Series Service Manual

4. Install the new lens.
a. Fully insert the lens assembly straight into the lens mount.
b. Rotate the lens cap clockwise to lock the lens in place.
c. Use a M3 Allen key to tighten the screw on the Lens Release button.

Replacing the complete light engine

To remove the complete light engine, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and main board bottom shielding.
See Replacing the main board and media board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the I/O board.
See Removing the I/O board
5. Remove the front cover.
See Removing the front cover
6. Remove the left-side cover.
See Removing the left-side cover
7. Remove the power supply module from the projector.
See Replacing the DC 12V power supply
8. Remove the laser driver board.
See Replacing the blue1 and 2 laser driver board
board on page 106.
9. Release the two quick-disconnectors of the pump and radiator module.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
on page 99.
on page 64.
on page 104.
on page 65.
on page 67.
on page 87.
on page 105, Replacing the red laser driver
Optics
77