Replacing A Projector's Foot - Christie HS Series Service Manual

See Replacing the blue1 and 2 laser driver board
board on page 106.
7. Remove the power supply module.
See Replacing the DC 12V power supply
page 90.
8. Remove the complete light engine.
See Replacing the complete light engine
9. Remove the fans 11.
See Replacing fan 11
10. Remove the AC inlet.
See Removing the AC inlet
11. Remove the elevator feet from the bottom cover.
See

Replacing a projector's foot

12. Remove the two M3 screws with a Phillips #1 screwdriver securing the holder of blower fan 11.
13. Remove the 23 M3 screws with a Phillips #1 screwdriver securing the bottom cover.
14. Remove the shielding base from the bottom cover.
15. If required, replace the bottom cover.
16. To re-install, follow these steps in reverse order.
Replacing a projector's foot
The adjustable feet can be raised or lowered when positioning the projector to make sure it is level
on all sides so the displayed image appears rectangular without any keystone.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 87,
on page 77.
on page 74.
on page 92.
on page 69.
Projector covers and feet
on page 105, Replacing the red laser driver
Replacing the main power supply on
69