Electronics; Removing And Installing The Fuse; Removing The Filter-L Switch - Christie HS Series Service Manual

Electronics

Learn how to replace the electronic components in the projector.

Removing and installing the fuse

A fuse must be installed in the projector for it to power on.
1. Turn off the projector.
2. Choose the 100V or 220V fuse by sliding the AC cover to the right or to the left.
3. Remove the screw on the fuse.
4. Release the fuse and replace the new one.
5. To re-install, follow these steps in reverse order.

Removing the filter-L switch

To remove filter-L switch, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board top shielding.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
84