Removing The Thermal Sensor Board; Replacing The Main Board And Media Board - Christie HS Series Service Manual

Removing the thermal sensor board

To remove the thermal sensor board, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board top shielding.
See

Replacing the main board and media board

3. On the main board, unplug the thermal sensor connector.
4. On the main board bottom shielding, remove the one M3 screws with a Phillips #1 screwdriver.
5. Remove the thermal sensor board.
6. Replace the thermal sensor board.
7. To re-install, follow these steps in reverse order.
Replacing the main board and media board
To remove the main board, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. To remove the main board top shielding, remove the nine screws with a Phillips #1 screwdriver.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
on page 99.
on page 64.
Printed circuit boards and sensors
99