Replacing The Main Power Supply - Christie HS Series Service Manual

18. Unplug the three connectors.
19. Remove the two M3 screws with a Phillips #1 screwdriver.
20. Replace the DC 12V power supply.
21. To re-install, follow these steps in reverse order.

Replacing the main power supply

The main power supply provide the power to laser bank and laser driver.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and main board bottom shielding.
See Replacing the main board and media board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the front cover.
See Removing the front cover
5. Remove the left-side cover.
See Removing the left-side cover
6. Remove the shielding cover on the left of the power supply.
See Replacing the DC 12V power supply
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
To main board
To main board fan 8
on page 64.
on page 64.
on page 65.
on page 67.
To fan 8
on page 99.
on page 87.
Electronics
90