Replacing The Dmd - Christie HS Series Service Manual

13. Remove the four M2.6 screws with a Phillips Jewelers screwdriver securing the combiner
module.
14. Replace the combiner module.
15. To re-install, follow these steps in reverse order.

Replacing the DMD

Replacing the DMD must be done in a clean room.
To remove the DMD, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and main board bottom shielding.
See Replacing the main board and media board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the I/O board.
See Removing the I/O board
5. Remove the front cover.
See Removing the front cover
6. Remove the left-side cover.
See Removing the left-side cover
7. Remove the power supply module from the projector.
See Replacing the DC 12V power supply
8. Remove the laser driver board.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
on page 99.
on page 64.
on page 104.
on page 65.
on page 67.
on page 87.
Optics
81