Christie HS Series Service Manual page 43

2. On the Update Details tab, select Please check firewall has been closed.
3. Click Next.
4. Connect the projector to AC and then power it on.
If the projector is connected to AC mains, but not powered on, the OPFU does not recognize the
projector.
5. When the source message is displayed on the bottom left of the projected image, click Next.
6. Connect the projector to the computer with a RJ45 cable.
a. Set the Default Gateway and Subnet Mask of the computer to match the projector.
b. Set the IP address of the computer to match the first three numbers of the projector.
For example, if the projector IP address is 192.168.000.100, set the computer IP address
to 192.168.000.xxx, where xxx is not 100.
c. On the Connect Projector to Computer tab, type the IP address of the projector.
d. Click Next.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
Firmware
43