Replacing The Tec Module - Christie HS Series Service Manual

See Replacing the complete light engine
10. Remove the thermal switch harnesses from clips.
11. Remove two M3 screws with a Phillips #1 screwdriver.
12. Replace the thermal switch.
13. To re-install, follow these steps in reverse order.

Replacing the TEC module

The TEC module provides thermal cooling to the DMD Chip.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and main board bottom shielding.
See Replacing the main board and media board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the front cover.
See Removing the front cover
5. Remove the left-side cover.
See Removing the left-side cover
6. Remove the complete light engine.
See Replacing the complete light engine
7. Remove the color wheel.
See Replacing the color wheel
8. Remove the combiner module.
See Replacing the combiner module
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 77.
on page 64.
on page 99.
on page 64.
on page 65.
on page 67.
on page 77.
on page 78.
on page 79.
Electronics
95