Removing The Right-Side Cover - Christie HS Series Service Manual

3. Cut off the cable tie.
4. Remove the six M3 screws with a Phillips #1 screwdriver.
5. On the front shielding, remove the 3M tapes.
6. Remove the front shielding.
7. Remove the nine M3 screws with a Phillips #1 screwdriver securing the front cover module.
8. Remove the front cover from the projector.
9. Remove the front IR sensor board.
See Replacing the front IR sensor board
10. Transfer the IR sensor board to the new front cover.
11. If required, replace the front cover.
12. To re-install, follow these steps in reverse order.

Removing the right-side cover

The right-side of the projector is determined by facing forward from rear of the projector.
1. Remove the top cover.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 98.
Projector covers and feet
66