Replacing the DC 12V power supply
To remove the DC 12V power supply, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board module.
See
Replacing the main board
3. Remove the main board bottom shielding.
See
Removing the rear cover
4. Remove the rear cover.
See
Removing the rear cover
5. Remove the front cover.
See
Removing the front cover
6. Remove the left-side cover.
See
Removing the left-side cover
7. On the the laser driver board, unplug three LVPS board connectors.
See
Replacing the blue 1 and 2 laser driver board
driver board
on page 102.
8. Loosen the five M3 captive screws with a Phillips #1 screwdriver securing the power supply
module.
9. Unplug the thermal switch connector.
HS Series 2K Service Manual—D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001468-02 Rev. 1 (01-2020)
Copyright ©2020 Christie Digital Systems USA Inc. All rights reserved.
on page 59.
on page 94.
on page 59.
on page 59.
on page 61.
on page 63.
on page 100,
Replacing the red laser
Electronics
74