Replacing The Low Voltage Power Supply Fan (Fan 9) - Christie CP2208-LP Service Manual

Estimated replacement time: 16 minutes per fan
1. Remove the top skin (on page 32).
2. Loosen the two captive screws on the bottom of the card cage air filter cover.
3. Pull the cover out and down.
4. Remove the front skin (on page 33).
5. Remove the side baffle assembly
6. Remove the high security cover (on page 40).
7. Disconnect the inline connector for each fan.
8. Pull the release lever on the inside of the fan pack.
9. Pull the fan pack vertically, then angle the fan pack towards you to remove it.
10. Remove each fan requiring repair, threading the fan harness through the rubber grommet.
11. Insert the new fan into the fan pack (in the proper airflow direction).
12. Lock the fan into place using pliers to pull the rubber standoffs through corner holes and
reroute the harness.
13. To re-install the fan pack, complete these steps in reverse order.
Replacing the low voltage power supply fan (fan
9)
Fan 9 provides air cooling to the low voltage power supply (LVPS) system.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Ventilation and cooling
51