Adjusting The Rod Assembly - Christie HS Series Service Manual

ID Part name
2 Test signal
3 Test pattern
4 Inspection items
1. On the IR remote keypad, press Menu and select Size & Position > Size Presets > Full
Size.
2. Enter Factory mode.
See Entering Factory mode
3. Select ADC Calibration > Help.
After a few seconds, the ADC calibration status changes from Doing to Done.

Adjusting the ROD assembly

Avoid over-adjusting the ROD to prevent damage.
Warning! If not avoided, the following could result in death or serious injury.
• Do not look into the projector lens when the laser is on. The bright light may result in permanent
eye damage.
• This projector has a built-in Class 4 laser module. Never attempt to operate the projector without
all covers properly installed, unless instructed to do so in this manual for service.
1. Remove the top cover.
See Removing the top cover
2. To power on with the top cover removed, firmly hold the interlock switch on the left-side cover.
3. Project an image of 100 inch in a dark environment (< 2 Lux).
4. Enter Service mode.
See Entering Service mode
5. Click Test Pattern, select the White Screen test pattern.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
Description
D13HD-HS: Analog 1920 x 1080 @60Hz
D13WU-HS: Analog 1920 x 1200 @60Hz
SMPTE BAR
Check if the ADC calibration status has changed from Doing to Done.
on page 19.
on page 64.
on page 20.
Service setups
25