Page 1
U se r Ma n u a l 020-000807-02 H Series, HS Series, GS Series (700, 850) Warping and Blending...
Page 2
The warranty does not apply to any product where the serial number has been removed or obliterated. The warranty also does not apply to any product sold by a reseller to an end user outside of the country where the reseller is located unless (i) Christie has an office in the country where the end user is located or (ii) the required international warranty fee has been paid.
Description Indicates disconnection from the channel network. Indicates connection to the channel network. The selected channel appears in a blue box. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
1. In the Projector Control dialog, switch to the Warp tab. 2. To change the cursor color, in the Cursor section, right click on Color and select the color. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc.
Adjust the inner and outer cursors after enabling warping. 1. Start with a minimal number of grids and gradually increase the number of grids. Christie recommends starting with a 2x2 setup. Using fewer grids allows for less warping. 2. Adjust the outer cursors as shown in red below.
3. To change the color of the test pattern, right-click on one of the color boxes and select a color. 4. Repeat step 3 for the other color box. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc.
A test pattern can help to tune edge blending. Before adjustment After adjustment H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
Use the New Blending feature to operate multiple projectors. To enable New Multi-Function, from the File menu, select New Blending. The Blending Settings dialog appears. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc.
8. In the IP Address field, type the IP address of the projector. 9. To apply the change, click Apply 10. .For the remaining projectors, repeat steps 7 to 9. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc.
3. In the Network section, enter the required IP address. 4. Click Connect. 5. To apply the previous settings, click Synchronize. H Series, HS Series, GS Series (700, 850) Warping and Blending User Manual 020-000807-02 Rev. 1 (07-2016) Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
Page 12
Corporate offi ces Worldwide offi ces USA – Cypress Australia Eastern Europe and India Singapore ph: 714-236-8610 ph: +61 (0) 7 3624 4888 Russian Federation ph: +91 (080) 6708 9999 ph: +65 6877-8737 ph: +36 (0) 1 47 48 100 Canada –...