Performing A Rs232 And Video Function Test On Hdbaset Port - Christie HS Series Service Manual

• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP.
a. Plug in power cord to the projector.
b. Connect the PC and projector using a RJ45 cable.
c. Turn on the projector.
d. On the IR remote keypad, press Menu and select Configuration > Communications
> LAN.
e. Make sure DHCP is disabled.
f. Record the following information:
• The IP address: 192.168.0.100 (default)
• The Subnet Mask: 255.255.255.0 (default)
2. In Network settings, set the projector IP address.
See Performing a network function test on the network port
3. Read the projector information.
See Performing a network function test on the network port
Performing a RS232 and video function test on
HDBaseT port
To perform the RS232 and video function test, complete the following steps.
1. Connect the CH-506TX, projector and PC as shown in step 5.
2. Switch the signal source to HDBaseT.
3. On the IR remote keypad, press the Menu button and select Configuration > Communica-
tions > Serial port > HDBaseT.
4. Set the PC Baud Rate to 115200.
5. Input the RS232 command (SYS?).
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
Service setups
on page 35.
on page 35.
37