Laser Safety Warnings - Christie HS Series Service Manual

Laser safety warnings

Your projector may be classified as a CLASS 1 LASER PRODUCT - RISK GROUP 2 according to IEC
60825-1:2014. These service instructions are applicable to your product. Follow the instructions
and safety precautions for this product.
Risk Group 3
This product is classified as CLASS 1 LASER PRODUCT - RISK GROUP 3 according to IEC 60825-
1:2014 and IEC 62471:2006.
Warning! If not avoided, the following could result in death or serious injury.
• This product must be installed within a restricted access location not accessible by the general
public.
• Only personnel who are trained on the precautions for the restricted access location can be granted
entry to the area.
• PERMANENT/TEMPORARY BLINDNESS HAZARD! Operators must control access to the beam within
the hazard distance or install the product at the height (greater than or equal to 3.0 m from the
floor to the beam) that prevents exposure of the spectators' eyes within the hazard distance.
• Possibly hazardous optical radiation emitted from this product (Risk group 3).
• This projector has a built-in Class 4 laser module. Never attempt to operate the projector without
all covers properly installed, unless instructed to do so in this manual for service.
• Any operation or adjustment not specifically instructed in the User manual creates the risk of
hazardous laser radiation exposure.
• Do not open or disassemble the projector as this may cause damage from exposure of laser
radiation.
• PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. Risk Group 3 IEC 62471:2006.
• Install the product so users and the audience cannot enter the restricted area at eye level.
• Follow the control, adjustment, or operation procedures to avoid damage or injury from exposure
of laser radiation.
• The instructions for the assembly, operation, and maintenance include clear warnings concerning
precautions to avoid possible exposure to hazardous laser radiation.
• Installing or replacing a lens must be done by a Christie qualified service technician to avoid
exposure to dangerous emission levels.
• Not for household use.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
Service guidelines
13