Introduction; Affected Products; Site Requirements; Power Connection - Christie HS Series Service Manual

Introduction

This document provides technical information for assisting Christie qualified technicians in the servicing
of the Christie HS Series projectors.
Every effort has been made to make sure the information in this document is accurate and
complete. However, due to continuing research all information is subject to change without notice.
Christie assumes no responsibility for omissions or inaccuracies.

Affected products

The following products are affected:
• Christie D13HD-HS
• Christie D13WU-HS

Site requirements

To safely install and operate the projector, the installation location must have restricted access for
authorized personnel only and meet these minimum requirements.
Notice. If not avoided, the following may result in equipment or property damage.
• Risk Group 3 products require restricted access.
• Replacement of optical light engine parts must be done in a clean room.

Power connection

The projector cables must be securely connected before turning the power on.
Warning! If not avoided, the following could result in death or serious injury.
• PERMANENT/TEMPORARY BLINDNESS HAZARD! No direct exposure to the beam must be
permitted. RG3 IEC 62471:2006.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
7