Replacing The Power Supply - Christie DHD410S Service Manual

5. Replace the speaker.
6. To re-install, follow these steps in reverse order.

Replacing the power supply

To remove the power supply, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board.
See
Replacing the main board
3. Remove the combiner module.
See
Replacing the combiner module
4. Remove the laser driver board.
See
Replacing the laser driver board
5. Remove the front cover.
See
Removing the front cover
6. Remove three hex screws with a Phillips #1 screwdriver securing the power supply.
7. Unplug the two connectors.
8. Replace the power supply.
9. To re-install, follow these steps in reverse order.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
on page 77.
on page 73.
on page 82.
on page 48.
To laser driver board
To main board
Electronics
58