Running A Mini Usb Port Performance Test; Completing A Picture In Picture/Picture By Picture Function Test; Performing A Network Function Test On The Network Port - Christie HS Series Service Manual

Running a mini USB port performance test

ID Part name
1 Test equipment
2 Test signal
3 Inspection item
4 Inspection distance
5 Criteria
To perform the video performance test by mini usb port, complete the following steps.
1. Connect the projector and PC using a USB cable.
2. Switch the signal source to Mini USB.
3. From My Computer, execute the Projector Autorun.exe.
The image of PC is projected.
Completing a picture in picture/picture by picture
function test
Always perform the picture in picture/picture by picture function test after repairing the main board,
or upgrading the scalar firmware. If the performance is not normal, replace the main board (see
Replacing the main board and media board
1. On the IR remote keypad, press Menu > Input Switching > PIP Menu.
2. Set PIP/PBP Enable to On.
3. Ensure each item is functioning normally.
Performing a network function test on the
network port
The following browsers are supported for this test:
• Internet Explorer: IE8 for WinXP, IE9 or higher for Win7, and IE11 for Win8.1 or Win10 is
required.
• Chrome: Version 49 or higher is required.
• Firefox: Version 46 or higher is required.
• Safari: Not supported.
To perform the network function test, complete the following steps.
1. Record the projector IP address.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
Description
Video generator
64 Gray RGBW
Mini USB port performance test
1.8 to 2.2 m
No abnormal color performance, line distortion, or noise exist on the screen
on page 99).
Service setups
35