Christie HS Series Service Manual page 108

3. To separate the keypad and the left cover, loosen the two M3 captive screws with a Phillips #1
screwdriver.
4. Take out the keyapd and keypad board from the projector.
5. Unplug the two connectors.
6. Remove the six M3 screws with a Phillips #1 screwdriver securing the keypad board.
7. To remove the keypad, take out the keypad board.
8. Remove the mylar which is phased on the keypad board.
9. Replace the keypad board.
10. To re-install, follow these steps in reverse order.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
To LED board
To main board
Printed circuit boards and sensors
108