Replacing The Photo Sensor Board; Replacing The Dmd Board - Christie HS Series Service Manual

Replacing the photo sensor board

To remove the photo sensor board, complete the following steps.
1. Remove the color wheel.
See Replacing the color wheel
2. Remove the one M2.6 screw with a Phillips Jewelers screwdriver securing the photo sensor
board.
3. Replace the photo sensor board.
4. To re-install, follow these steps in reverse order.

Replacing the DMD board

To remove the DMD board, complete the following steps.
1. Remove the complete light engine.
See Replacing the complete light engine
2. Remove the color wheel.
See Replacing the color wheel
3. Remove the combiner module.
See Replacing the combiner module
4. Remove the TEC module.
See Replacing the TEC module
5. To separate the DMD board from the DMD module, remove the six M3 screws with a Phillips #1
screwdriver.
6. Remove the DMD board.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 78.
on page 77.
on page 78.
on page 79.
on page 95.
Printed circuit boards and sensors
109