Projector covers and
feet
Learn how to remove the covers and feet of the projector.
Removing the top cover
The top cover and top shielding provide access to the main board and other components.
1. On the rear cover side, remove the three captive screws with a Phillips #1 screwdriver.
2. Slide the top cover towards the front of the projector and lift it.
3. Remove the top cover.
4. If required, replace the top cover.
5. To re-install the top cover, follow these steps in reverse order.
Removing the rear cover
The rear cover provides access to keypad board and AC inlet module.
1. Remove the top cover.
See
Removing the top cover
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
64