Adjusting Bore-Sight - Christie HS Series Service Manual

5. Confirm whether the distance values are differ less than 3 cm from the lens specification
values.
• If the value does not meet the lens specification within 3 cm, adjust the three set screws
with a M4 Allen key.
• If the value does meet the lens specification, perform a bore-sight adjustment.

Adjusting bore-sight

Notice. If not avoided, the following may result in equipment or property damage.
• Do not adjust the set screws beyond two full turns in the clockwise direction to avoid equipment
damage.
The bore-sight adjustment on HS Series projectors is opposite to the bore-sight adjustment on E,
G, and GS Series projectors. Adjust the three set screws with a M4 Allen key to make the image
clear, crisp, and sharp.
1. To adjust the focus to position 1 on the screen, click Focus.
2. Once position 1 is in focus, check position 2. If position 2 is not in focus, use the focus Up or
Down key to bring position 2 into focus on the screen.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
1
2
A B
C
3
Service setups
27