5. Remove the filter-R switch harnesses from the clips.
6. Separate the filter-R switch and hold cover.
7. Replace the filter-R switch.
8. To re-install, follow these steps in reverse order.
Removing the AC detect switch
The AC detect switch provide the projector AC source change from 15A to 20A.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board top shielding.
See
Replacing the main board and media board
3. On the main board, unplug the AC detect connector.
4. Remove the rear cover.
See
Removing the rear cover
5. Remove the front cover.
See
Removing the front cover
6. Remove the left-side cover.
See
Removing the left-side cover
7. Remove the two M3 screws with a Phillips #1 screwdriver.
8. Separate the AC detect switch and hold cover.
9. Replace the AC detect switch.
10. To re-install, follow these steps in reverse order.
Removing the pump and radiator module
To remove the pump and radiator module, complete the following steps.
1. Remove the top cover.
See
Removing the top cover
2. Remove the main board and main board bottom shielding.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
on page 99.
on page 64.
on page 65.
on page 67.
on page 64.
Electronics
86