Replacing The Power Supply - Christie GS Series Service Manual

5. Remove the mylar which is phased on the thermal switch cable.
6. Unplug the connector for the thermal switch cable.
7. To replace the thermal switch, remove one M3 screws with a Phillips #1 screwdriver.
8. To re-install, follow these steps in reverse order.

Replacing the power supply

To remove the power supply, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
3. Remove the rear cover.
See Removing the rear cover
4. Remove the front cover.
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 83.
on page 64.
Electronics
77