Christie HS Series Service Manual page 70

1. Ensure the projector is in a secure position.
Christie does not recommend having the projector overhang when replacing the feet, unless the
projector is securely positioned.
2. Remove the top cover.
See Removing the top cover
3. Remove the main board and main board bottom shielding.
See Replacing the main board and media board
4. Remove the rear cover.
See Removing the rear cover
5. Remove the I/O board.
See Removing the I/O board
6. Remove the front cover.
See Removing the front cover
7. Remove the left-side cover.
See Removing the left-side cover
8. Remove the power supply module from the projector.
See Replacing the DC 12V power supply
9. Unlock the four nuts with a M6 socket driver.
10. Loosen the screw and remove the foot.
11. Replace the foot.
12. Repeat steps 2 and 7 for any additional feet that need to be replaced.
13. To re-install, follow these steps in reverse order.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 64.
on page 99.
on page 64.
on page 104.
on page 65.
on page 67.
on page 87.
Projector covers and feet
70