Christie HS Series Service Manual page 75

See Removing the left-side cover
7. Remove the power supply module from the projector.
See Replacing the DC 12V power supply
8. Remove the laser driver board.
See Replacing the blue1 and 2 laser driver board
board on page 106.
9. Remove the complete light engine.
See Replacing the complete light engine
10. To remove fan 11, remove the three M3 screws with a Phillips #1 screwdriver.
11. Remove the rubber gasket from fan module.
12. Replace the affected fan.
13. To re-install, follow these steps in reverse order.
HS Series D13 Service Manual
020-000892-03 Rev. 1 (12-2019)
on page 67.
on page 87.
on page 105,
on page 77.
Ventilation and cooling
Replacing the red laser driver
75