Accessing The Generated User Account Password; Resuming Projector Operation After An Ac Power Interruption; Keeping Electronics On In Standby Mode - Christie Mirage 304K User Manual

Create your password using 4 to 32 characters. The password can be any combination of
letters, numbers, and symbols (ASCII-standard characters only). Accents and accented
characters are not supported.
4. Click Confirm and retype your new password.
5. Click Apply.

Accessing the generated user account password

If the user account password is not available, the generated password can be used to access the
functionality on the web interface.
Note the following about the generated user account password:
• The generated password can be used to change the user account password.
• Every time the user account password is updated, the generated password is changed.
• If the projector defaults are reset using either the Reset Projector Defaults or Reset
Factory Defaults features, the user account password is reset.
This feature is accessed from the display panel on the projector and the on-screen display.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
3. Select Generated password.
The generated password is displayed in this field.
Resuming projector operation after an AC power
interruption
If an AC power interruption occurs while Auto Power Up is enabled, the projector will resume operation
in the same state it was prior to the loss of power.
1. Select MENU > System Settings > Power Settings.
2. Select Auto Power Up.
3. To enable automatically powering up the projector after an AC interruption, select Enter.

Keeping electronics on in standby mode

When the projector is placed in standby mode, the light source will be turned off but the electronics
and required fans remain on.
1. Select MENU > System Settings > Power Settings.
2. Select Keep Electronics On In Standby.
3. To enable electronics remaining on in standby mode, select Enter.
Mirage 304K (Bm.1) User Guide
020-101778-12 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
37