Electronics; Removing And Installing The Fuse; Removing The Ac Inlet - Christie GS Series Service Manual

Electronics

Learn how to replace the electronic components in the projector.

Removing and installing the fuse

To remove and install the fuse, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the screw with a flathead screwdriver.
3. Release the fuse.
4. Replace the fuse with a new one, tightening the screw attached.
5. To re-install, follow these steps in reverse order.

Removing the AC inlet

Remove the AC inlet from the rear cover.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board and I/O board.
See Replacing the main board and I/O board
GS Series 1075 Service Manual
020-001236-02 Rev. 1 (12-2019)
on page 63.
on page 63.
on page 83.
74