Resuming Projector Operation After An Ac Power Interruption; Keeping Electronics On In Standby Mode; Enabling Direct Pass-Through Of Hdmi, 3G, And Displayport Input Signals - Christie Mirage 4K40-RGB User Manual

• Every time the user account password is updated, the generated password is changed.
• If the projector defaults are reset using either the Reset Projector Defaults or Reset
Factory Defaults features, the user account password is reset.
This feature is accessed from the display panel on the projector and the on-screen display.
1. From the display panel, select MENU > Admin > Service.
2. Enter the service password.
3. Select Generated password.
The generated password is displayed in this field.
Resuming projector operation after an AC power
interruption
If an AC power interruption occurs while Auto Power Up is enabled, the projector will resume operation
in the same state it was prior to the loss of power.
1. Select MENU > System Settings > Power Settings.
2. Select Auto Power Up.
3. To enable automatically powering up the projector after an AC interruption, select Enter.

Keeping electronics on in standby mode

When the projector is placed in standby mode, the light source will be turned off but the electronics
and required fans remain on.
1. Select MENU > System Settings > Power Settings.
2. Select Keep Electronics On In Standby.
3. To enable electronics remaining on in standby mode, select Enter.
Enabling direct pass-through of HDMI, 3G, and
DisplayPort input signals
Allow the signals from HDMI, 3G, and DisplayPort inputs to pass through another projector.
1. Select MENU > Configuration > Input Settings > Enable Video Loop Out.
2. To enable passing HDMI, 3G, and DisplayPort input signals through to another projector, select
Enter.
Mirage 4K40-RGB User Guide
020-103015-05 Rev. 1 (04-2020)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Configuring system settings
36