JUKI FX-1 Maintenance Manual page 5

Situations in Which It Is Necessary to Turn Off Power Supply
1. In the case of an abnormality or an accident, or in the event of power failure,
immediately turn off power supply.
2. In order to prevent accidents due to unintended start-up of the machine, carry out
inspection, repair, or cleaning of the machine only after turning off power supply.
3. When drawing out the power supply plug, do it by holding the plug itself, not the
cord.
Transport
1. When lifting the machine or moving it, take sufficient safety measures so that no
dropping accidents will occur.
Unpacking
1. Read all instructions shown on the transport-use container.
2. Never cut tapes with a cutter.
3. Retain delivery-use materials.
Installation
1. To prevent the occurrence of any accident due to unintended moving of the
machine in operation, make casters float using a height adjuster.
2. Install this machine at a flat position.
3. To prevent the occurrence of electric shock, power leakage, or fires, use attached
products regarding cables, and link them to the specified positions.
4. To prevent electric shock, power leakage, or fires, make sure that irrational force
will be applied to the cables while the machine is in operation.
5. Securely fix the power supply plug and the connector of an I/F cable. When
drawing out the power supply plug or the I/F cable, do it by holding the connector
unit.
Before Operation
1. To prevent accidents to human bodies, make sure before supplying power that
there is no damage, coming off of parts, or loosening of connectors and cables.
2. To prevent bodily accidents, never put in your hand into the driving unit.
To turn off power supply means to turn off
a power supply switch and then to draw out
a power plug from a receptacle or to
separate the power cable from the supply
side.
Hereinafter the same.
Matters of Caution at Each of Its Use Stages
CAUTION
III