Adjusting The Speed Controller Of The Bank-Up Cylinder (Optional Replacement Table) - JUKI FX-1 Maintenance Manual

FX-1/FX-1R Maintenance Manual
8-6. Adjusting the Speed Controller of the Bank-Up Cylinder
(Optional Replacement Table)
(1) Adjust the speed controller on the cylinder, which has been replaced in the previous section.
(2) The speed controllers have been set so that the bank-up cylinder completes ascent/descent
operation in two to three seconds. (When assembled)
UP speed :
If the up speed of the cylinder is too fast, turn the speed controller adjustment screw clockwise.
DOWN speed:
If the down speed of the cylinder is too fast, turn the speed controller adjustment screw
clockwise.
(3) If the up and down speeds of the left and right cylinders are the same, lock the adjustment
screws of the speed controllers with the lock screws.
(4) After the adjustment screws have been locked, recheck the up and down speeds.
To be adjusted by the upper speed controller.
To be adjusted by the lower speed controller.
To make the speed slower.
Figure 8-6-1
UP speed adjustment
DOWN speed adjustment
8-7
Rev. 2.00