FX-1/FX-1R Maintenance Manual
14-4. Running the cables and setting up the driver
The following shows how to run the cables and set up the driver.
Front reference
IN/OUT AWC driver
Axis
switch "4"
Motor cable
機ン定D
setting
rotary
Sensor cable
Position relay board
Figure 14-4-1
Position relay board
• Connect the sensor cables to CN25.
• Set the jumper
setting of W5
as shown in the
figure on the right.
To the top of the transport unit.
14-4
×
3
1
To the inside of the chassis (to
be passed through a position
between the conveyor mount
plate S and chassis).
Rev. 2.00