Replacing The Occ Coaxial/Angle Light Board Assemblies - JUKI FX-1 Maintenance Manual

FX-1/FX-1R Maintenance Manual

4-3. Replacing the OCC Coaxial/Angle Light Board Assemblies

(1) Detach the light assembly from the XM base using the procedure described in section 4-1,
Replacing the OCC Assembly.
(2) Remove the SEMS cap bolts
(3) Remove the SEMS cap bolts
(4) Reassemble the components in the reverse order of disassembly.
(5) After the OCC light board has been replaced, it is necessary to adjust the OCC light. (See 4-7,
List of Readjustment Items After Replacement.)
Figure 4-3-1 Replacing the OCC Coaxial/Angle Light Board Assembly
to replace the OCC coaxial light board assembly.
to replace the OCC angle light board assembly.
4-3
SEMS cap
bolts (× 2)
Coaxial light
board assembly
Angle light board
assembly
SEMS cap bolts
(× 4)
Rev. 2.00