JUKI FX-1 Maintenance Manual page 184

FX-1/FX-1R Maintenance Manual
• Support table motor driver (STBL)
• Center motor driver (CENT)
• Automatic PWB width adjustment motor driver (AWCC)
When using the optional automatic PWB width adjustment unit, the following driver is added.
• Automatic PWB width adjustment motor driver (AWCS)
The following figure shows the layout of the drivers inside the base frame.
AWCS
AWCC
CENT
Set the stepping motor driver axis selection switch and function setting switch as shown below.
Driver
STBL
CENT
AWCC (CENT)
∗ AWCS (IN/OUT)
∗ AWCS (IN/OUT) is optional.
See Subsections 3-5-3-11 and 4-7-1-1 of MS Parameter manual.
STBL
Axis setting rotary switch
軸設定ロータリーＳＷ
Set value of axis
selection/function setting switch
See the figure on the right.
2
3
4
13-30
L900E121000
L900E021000
L900E021000
L900E021000
Function setting DIP-switch
機能設定ＤＩＰ-ＳＷ
ON
O
N
1 2 3 4 5 6 7 8
OFF
O
N
1 2 3 4 5 6 7 8
STBL DIP-switch setting
STBL DIP-SWの設定
Rev. 2.00