JUKI FX-1 Maintenance Manual page 193

FX-1/FX-1R Maintenance Manual
(2) SET UP switch
Switch key supplied with
• Parts used
Key cover (HA00535003A)
Key switch actuator (HA005350020)
Bezel (HA005520020)
Fit the bezel (black) into the cover FUR panel.
Push the key cover into the key switch actuator until a click is heard.
Insert the actuator (assembled at 3) into the black bezel, insert the bezel (silver) from the
back of the panel and secure it with the fixing nut.
(3) F/R SELECT, BANK ENABLE switch
• Parts used
OPERATION SW CABLE ASM (40002251) or FEEDER SW CABLE ASM (40002252)
Lens (Transparent): HA00553002A →F/R SELECT（OPERATION SW）
Lens (Green): HA005530020
Bezel: HA005530010
Remove the bezel fixing nut. Fit the switch into the switch panel and assemble it with the
fixing nut.
Finally, fit the switch element (with a cable) from the back of the panel. Direction of the switch
element is not important. It can be assembled in either direction
the machine
Bezel for key
switch
→BANK ENABLE（FEEDER SW）
Bezel
Key switch actuator
13-39
Projection part is put
on the left when
viewed from the front.
Rev. 2.00